Categories
Electronics Fabrication Mechanical Programming

Nixie Pipe – Modern Day LED Nixie Tube

Nixie Pipe is my interpretation of a modern day Nixie Tube – the cold-cathode vacuum gas-filled tubes from the 1960s. The project came about when I decided to make a clock for my kitchen, with specific requirement for an egg timer function! I’ve always wanted to make a Nixie Tube clock but having completed a […]

Categories
Fabrication

Chess Table

We needed a coffee table for our new house but had yet to find the right thing. I found this tired black circular table outside a neighbour’s house and was inspired to create a nice top for it.

Categories
Electronics Fabrication Mechanical

Whitterm-220 Clever Serial Terminal

21/12/18 UPDATE: Hello to Hack a Day readers. This project was shared when I did it but re-posted recently. It is 2.5 years old and there are many things I would do differently. I am considering work on a IO board specific to the project (RS232 driver, GPIO break-out, proper RX/TX LED buffers and potentially […]

Categories
Electronics Fabrication Mechanical Programming

Nixie Tube Energy Meter

Featured on Hack a Day Having recently bought a house, project time has been a bit thin on the ground. As a standard terrace house, the consumer unit and electricity meter were in the entrance hallway, exposed and looking a bit naff. I liked the look of the meter so I quickly created a box […]

Categories
Electronics Fabrication Mechanical Programming

Noise Crayon – Noise Amplitude to Light Spectrum Converter

Continuing on from my Ambient Noise Level Indicator, I wanted to create an enclosure and make it stand-alone – not requiring a computer to do the processing. I ended up with a little device that converts noise amplitude to the light spectrum: Noise Crayon. The Ambient Noise Level Indicator used the MCU serial host Processing […]

Categories
Electronics Fabrication Mechanical Programming

Wooden Bits – Binary Clock

I’ve been meaning to make a binary wall clock for a while and to also try out kerf bending with the laser cutter. What put me off creating kerf bends before I found OpenSCAD, was the manual creation of all the lines in the right places. It’s the kind of repetitive, uniform task computers were […]

Categories
Fabrication Mechanical Programming

Laser Cut Adaptable Wire Dispenser in OpenSCAD

I wanted a wire dispenser that wasn’t fixed in place so I could move it to where I was working. To my surprise, such a thing doesn’t exist (I couldn’t seem to find fixed ones either, other than using a kitchen towel rail). Keen to put my new found love for OpenSCAD to use, I […]

Categories
Fabrication Mechanical

Laser Cut iPhone 5s Dock

Categories
Electronics Fabrication Mechanical Modification

SoundBar VU Meter Laminated Wooden Speaker

I felt that the battery powered Bluetooth speaker I made could be improved with more colour! Taking a leaf from the VU meters on amplifiers of the 80s, I decided it would be neat to sandwich clear acrylic between the plywood layers, each with an integrated LED that would form a full body amplitude meter. […]

Categories
Fabrication Mechanical Modification

Bike Hub Pencil Holder